RIBBON FISH TUTORIAL
COPY TỪ ĐÂY :
<u>The contents of this section is only viewable by members - Please login or register to view</u>
It might take you a couple trial & error to get the fish looks right. The first time I did this fish for Gallery Idol, I didn't have any direction on how to do it. I basically figured it out myself just by looking at the end result. Took me at least an hour for my first try. This time, it only took 10 minutes.
Step 1:
Using a 5/8" ribbon, cut it to about 7"-8". I prefer longer, so you can play with it easier. Overlap them just like in the picture below. The opening in between t he 2 ribbon is basically the fish mouth. You can adjust it to however big or wide you want the mouth to be and glue the overlap ribbon. I used "Love My Tapes" permanent adhesive for this. And make sur eyou only glue the very top part to the 2nd, and not to the 3rd or bottom layer or you'll end up with sickly looking fish with flat head. You want the head to puff a bit. Puffy head = healthy fish. 
<u>The contents of this section is only viewable by members - Please login or register to view</u>
Step 2:
To tie the body together, I folded my 5/8" ribbon in half & glued it (see the skinny strip above). If you have a skinnier ribbon, then you can use the skinny ribbon for it. Now, you want to pinch the ribbon together, like the picture below.
<u>The contents of this section is only viewable by members - Please login or register to view</u>
Step 3:
Using a glue dot, wrap the skinny ribbon around the body. Make sure you put the glue dot on the back side to keep the fish look neat. Cut the end of both end, so it looks like fish tail.
Cut two 2" long skinny ribbon for the fin. Or if you don't have one, cut the 5/8" ribbon in half like I did. If you do this, then you have to seal the fray end with the tip of hit glue gun or used a lighter. Just remember, fire hot! If you use lighter, make sure you don't get the fire too close. Only close enough to get it sealed the edges. Sorry, couldn't take pic for when I did this since hubby wasn't anywhere close when I did this, so no second person to take the pic & I can't hold lighter & camera at the same time.
<u>The contents of this section is only viewable by members - Please login or register to view</u>
Step 4:
Overlap & glue the 2" ribbon like shown below.
<u>The contents of this section is only viewable by members - Please login or register to view</u>
Step 5:
Glued the fin to the body. As you can see, on the above picture I attached the fin right in the middle of the body. That was wrong position. The picture below show the right position. Add a wiggly eye and you're done!!
<u>The contents of this section is only viewable by members - Please login or register to view</u>
So, what you think? Easy, right? With a fish like this, you don't need much of anything else to make your card shine. I made a super simple, CAS looking card. I do adore my fish.
<u>The contents of this section is only viewable by members - Please login or register to view</u>
Thắt bows tuyệt mỹ trong khoảnh khắc 
Mình làm vừa lâu lắc vừa không đều 
.
.K.M. sẽ sưu tầm mang tiếp vào vài kiểu thắt nơ khác cho các bạn thực tập nhé